Re: Installing and running OpenBSD on Sun Blade 1500 - Please help a newb!

Hi Mark,

it should but it doesn't seem to? Maybe I've stuffed up the install. I
followed the instructions on the OpenBSD site - do I then need to do
anything further? A follow up guide or something would be great.

Thanks for your reply.

Angus

On Tue, May 25, 2010 at 10:31 PM, Mark Kettenis <[email protected]>wrote:

> > Date: Tue, 25 May 2010 16:52:41 +1000
> > From: Angus Beath <[email protected]>
> >
> > Hi guys,
> >
> > recently I've been given a Blade 1500 with a XVR-600. I've played with
> Linux
> > a lot over the years but OpenBSD confounds me! I have managed to install
> > OpenBSD on this device, but I'm at a bit of a loss of where to go from
> here.
> > I know that xenocera supports the XVR-600 using the wildcatfb and ifb
> > drivers but how to get them into a place where X can see them and
> implement
> > them is confusing me. Any help will be very greatly appreciated.
>
> If your machine has just that XVR-600, it should just work.