Re: Installing and running OpenBSD on Sun Blade 1500 - Please help a newb!

> Date: Wed, 26 May 2010 11:56:00 +1000
> From: Angus Beath <[email protected]>
> 
> Nick,
> 
> I followed (to the letter) the Sparc installation FAQ. After reboot, I ran X
> at the # prompt and it immediately dropped me back to the # prompt. I have
> run through the Sparc64 X notes and changed the aperture to 1.
> 
> The X log is as follows:
> 
> (--) Using wscons driver
> 
> X.Org X Server 1.6.5
> Release Date: 2009-10-11
> X Protocol Version 11, Revision 0
> Build Operating System: OpenBSD 4.7 sparc64
> Current Operating System: OpenBSD blade1500.INtelephony.local 4.7
> GENERIC#258 sparc64
> Build Date: 15 March 2010  06:22:14PM
> 
>         Before reporting problems, check http://wiki.x.org
>         to make sure that you have the latest version.
> Markers: (--) probed, (**) from config file, (==) default setting,
>         (++) from command line, (!!) notice, (II) informational,
>         (WW) warning, (EE) error, (NI) not implemented, (??) unknown.
> (==) Log file: "/var/log/Xorg.0.log", Time: Wed May 26 11:47:38 2010
> (II) Loader magic: 0x1b20
> (II) Module ABI versions:
>         X.Org ANSI C Emulation: 0.4
>         X.Org Video Driver: 5.0
>         X.Org XInput driver : 4.0
>         X.Org Server Extension : 2.0
> (II) Loader running on openbsd
> (--) PCI: (0:0:6:0) 10b9:7101:0000:0000 Acer Labs M7101 Power rev 0
> (--) PCI: (1:0:3:0) 3d3d:07a2:3d3d:1047 3D Labs Wildcat 5110 rev 1, Mem @
> 0x04000000/67108864, 0x00100000/131072, 0x02000000/
> 33554432, BIOS @ 0x????????/65536
> Primary device is not PCI
> (==) Using default built-in configuration (12 lines)
> (==) --- Start of built-in configuration ---
>         Section "Device"
>                 Identifier      "Builtin Default wsfb Device 0"
>                 Driver  "wsfb"
>         EndSection
>         Section "Screen"
>                 Identifier      "Builtin Default wsfb Screen 0"
>                 Device  "Builtin Default wsfb Device 0"
>         EndSection
>         Section "ServerLayout"
>                 Identifier      "Builtin Default Layout"
>                 Screen  "Builtin Default wsfb Screen 0"
>         EndSection
> (==) --- End of built-in configuration ---

Grr, things got broken in 4.7.  For now you'll need a minimal
xorg.conf with something like the following contents:

Section "Device"
        Identifier  "Device0"
        Driver      "wildcatfb"
EndSection