sparc 5.2-beta bsd.rd doesn't get IP address from DHCP

"Sebastian Reitenbach" <[email protected]>
Newsgroups gmane.os.openbsd.sparc
Message-ID <39ca-4ff3ee00-85-6b8b4580@213084886>
Hi,

just tried to install from the fresh 5.2-beta bsd.rd, but it doesn't get an IP address via DHCP.
It seems to have a problem to detect the link on the le0 interface.
Booting back with the 5.1-current, normal bsd GENERIC, it just works.
see both dmesgs below.

Rebooting with command: disk bsd.rd                                   
Boot device: /iommu/sbus/espdma@5,8400000/esp@5,8800000/sd@3,0  File and args: bsd.rd
>> OpenBSD BOOT 2.6
Booting bsd.rd
Loading at physical address 400000
3329948+409020=0x390ea0
console is ttya
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2012 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 5.2-beta (RAMDISK) #9: Wed Jun 27 18:30:54 MDT 2012
    [email protected]:/usr/src/sys/arch/sparc/compile/RAMDISK
real mem = 200937472 (191MB)
avail mem = 193236992 (184MB)
mainbus0 at root: SUNW,SPARCstation-5
cpu0 at mainbus0: MB86907 @ 170 MHz, on-chip FPU
cpu0: 16K instruction (32 b/l), 16K data (32 b/l), 512K external (32 b/l) DVMA coherent cache enabled
obio0 at mainbus0
clock0 at obio0 addr 0x71200000: mk48t08 (eeprom)
timer0 at obio0 addr 0x71d00000 delay constant 82
zs0 at obio0 addr 0x71100000 pri 12, softpri 6
zstty0 at zs0 channel 0: console
zstty1 at zs0 channel 1
zs1 at obio0 addr 0x71000000 pri 12, softpri 6
zskbd0 at zs1 channel 0: no keyboard
zstty2 at zs1 channel 1: mouse
slavioconfig at obio0 addr 0x71800000 not configured
auxreg0 at obio0 addr 0x71900000
power0 at obio0 addr 0x71910000
fdc0 at obio0 addr 0x71400000 pri 11, softpri 4: chip 82077
iommu0 at mainbus0 addr 0x10000000: version 0x5/0x0, page-size 4096, range 64MB
sbus0 at iommu0: 21.250 MHz
dma0 at sbus0 slot 5 offset 0x8400000: rev 2
esp0 at dma0 offset 0x8800000 pri 4: ESP200, 40MHz
scsibus0 at esp0: 8 targets, initiator 7
cd0 at scsibus0 targ 2 lun 0: <MATSHITA, CD-ROM CR-504, ST23> SCSI2 5/cdrom removable
sd0 at scsibus0 targ 3 lun 0: <IBM, DCAS32160SUN2.1G, S60B> SCSI2 0/direct fixed serial.IBM_DCAS32160SUN2.1GF2583160_
sd0: 2063MB, 512 bytes/sector, 4226725 sectors
"SUNW,bpp" at sbus0 slot 5 offset 0xc800000 not configured
ledma0 at sbus0 slot 5 offset 0x8400010: rev 2
le0 at ledma0 offset 0x8c00000 pri 6: address 08:00:20:89:d9:b5
le0: 16 receive buffers, 4 transmit buffers
"SUNW,CS4231" at sbus0 class serial slot 4 offset 0xc000000 not configured
"power-management" at sbus0 slot 4 offset 0xa000000 not configured
cgsix0 at sbus0 slot 3 offset 0x0 pri 9: SUNW,501-2325, 1152x900, rev 11
wsdisplay0 at cgsix0
wsdisplay0: screen 0 added (std, sun emulation)
bootpath: /iommu@0,10000000/sbus@0,10001000/espdma@5,8400000/esp@5,8800000/sd@3,0
root on rd0a swap on rd0b dump on rd0b
erase ^?, werase ^W, kill ^U, intr ^C, status ^T

Welcome to the OpenBSD/sparc 5.2 installation program.
(I)nstall, (U)pgrade or (S)hell? i
At any prompt except password prompts you can escape to a shell by
typing '!'. Default answers are shown in []'s and are selected by
pressing RETURN.  You can exit this program at any time by pressing
Control-C, but this can leave your system in an inconsistent state.

Terminal type? [sun] 
System hostname? (short form, e.g. 'foo') warbird

Available network interfaces are: le0.
Which one do you wish to configure? (or 'done') [le0] 
IPv4 address for le0? (or 'dhcp' or 'none') [dhcp] 
Issuing hostname-associated DHCP request for le0.
le0: no link ............. sleeping
Issuing free-roaming DHCP request for le0.
le0: no link ............. sleeping
Available network interfaces are: le0.
Which one do you wish to configure? (or 'done') [le0] 

>> OpenBSD BOOT 2.6
Booting bsd
Loading at physical address 400000
3237020+481972 [52+150528+132973]=0x3d1468
[ using 283928 bytes of bsd ELF symbol table ]
console is ttya
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2012 OpenBSD. All rights reserved.  http://www.OpenBSD.org

uvm_km_kmem_grow: grown to 0xfe000000
OpenBSD 5.1-current (GENERIC) #62: Sun May 27 12:05:06 MDT 2012
    [email protected]:/usr/src/sys/arch/sparc/compile/GENERIC
real mem = 200933376 (191MB)
avail mem = 192966656 (184MB)
mainbus0 at root: SUNW,SPARCstation-5
cpu0 at mainbus0: MB86907 @ 170 MHz, on-chip FPU
cpu0: 16K instruction (32 b/l), 16K data (32 b/l), 512K external (32 b/l) DVMA coherent cache enabled
obio0 at mainbus0
clock0 at obio0 addr 0x71200000: mk48t08 (eeprom)
timer0 at obio0 addr 0x71d00000 delay constant 82
zs0 at obio0 addr 0x71100000 pri 12, softpri 6
zstty0 at zs0 channel 0: console
zstty1 at zs0 channel 1
zs1 at obio0 addr 0x71000000 pri 12, softpri 6
zskbd0 at zs1 channel 0: no keyboard
zsms0 at zs1 channel 1
wsmouse0 at zsms0 mux 0
slavioconfig at obio0 addr 0x71800000 not configured
auxreg0 at obio0 addr 0x71900000
power0 at obio0 addr 0x71910000
fdc0 at obio0 addr 0x71400000 pri 11, softpri 4: chip 82077
iommu0 at mainbus0 addr 0x10000000: version 0x5/0x0, page-size 4096, range 64MB
sbus0 at iommu0: 21.250 MHz
dma0 at sbus0 slot 5 offset 0x8400000: rev 2
esp0 at dma0 offset 0x8800000 pri 4: ESP200, 40MHz
scsibus0 at esp0: 8 targets, initiator 7
cd0 at scsibus0 targ 2 lun 0: <MATSHITA, CD-ROM CR-504, ST23> SCSI2 5/cdrom removable
sd0 at scsibus0 targ 3 lun 0: <IBM, DCAS32160SUN2.1G, S60B> SCSI2 0/direct fixed serial.IBM_DCAS32160SUN2.1GF2583160_
sd0: 2063MB, 512 bytes/sector, 4226725 sectors
bpp0 at sbus0 slot 5 offset 0xc800000: DMA2
ledma0 at sbus0 slot 5 offset 0x8400010: rev 2
le0 at ledma0 offset 0x8c00000 pri 6: address 08:00:20:89:d9:b5
le0: 16 receive buffers, 4 transmit buffers
audiocs0 at sbus0 slot 4 offset 0xc000000 pri 9
audio0 at audiocs0
"power-management" at sbus0 slot 4 offset 0xa000000 not configured
cgsix0 at sbus0 slot 3 offset 0x0 pri 9: SUNW,501-2325, 1152x900, rev 11
wsdisplay0 at cgsix0 mux 1
wsdisplay0: screen 0 added (std, sun emulation)
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
bootpath: /iommu@0,10000000/sbus@0,10001000/espdma@5,8400000/esp@5,8800000/sd@3,0
root on sd0a (767d44393957fabc.a) swap on sd0b dump on sd0b
Automatic boot in progress: starting file system checks.
/dev/sd0a (767d44393957fabc.a): file system is clean; not checking
/dev/sd0e (767d44393957fabc.e): file system is clean; not checking
/dev/sd0d (767d44393957fabc.d): file system is clean; not checking
setting tty flags
pf enabled
starting network
DHCPREQUEST on le0 to 255.255.255.255 port 67
DHCPACK from 10.0.0.27 (00:00:24:c9:d4:98)
bound to 10.0.0.25 -- renewal in 21600 seconds.
starting early daemons: syslogd pflogd ntpd.
starting RPC daemons:.
savecore: no core dump
...
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.