Re: sparc 5.2-beta bsd.rd doesn't get IP address from DHCP

On Wednesday, July 4, 2012 23:18 CEST, Stuart Henderson <[email protected]> wrote: 
 
> On 2012/07/04 22:41, Sebastian Reitenbach wrote:
> > The /bsd I tried, and which works is an older 5.1-current, but I also just tried booting the 5.2-beta /bsd, which 
> > also works. Its only the 5.2-beta bsd.rd which doesn't seem to detect a link on the interface.
> 
> Does it work with 5.0 bsd.rd?
> 5.1?
> 
> I have archived sparc bsd.rd kernels from snapshots going back
> to July 2009 if you want to narrow it down.
> 
 
 Good idea. So I did, and found that the last 5.1-snapshot kernel, from the 20120528, before the 5.2-beta
works well. So the change causing the problem must be in the last months.
 
Sebastian 

Rebooting with command: disk bsd.rd.20120528                          
Boot device: /iommu/sbus/espdma@5,8400000/esp@5,8800000/sd@3,0  File and args: bsd.rd.20120528
>> OpenBSD BOOT 2.6
Booting bsd.rd.20120528
Loading at physical address 400000
3329756+409012=0x390dd8
console is ttya
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2012 OpenBSD. All rights reserved.  http://www.OpenBSD.org

uvm_km_kmem_grow: grown to 0xfe000000
OpenBSD 5.1-current (RAMDISK) #3: Sun May 27 13:02:47 MDT 2012
    [email protected]:/usr/src/sys/arch/sparc/compile/RAMDISK
real mem = 200937472 (191MB)
avail mem = 193236992 (184MB)
mainbus0 at root: SUNW,SPARCstation-5
cpu0 at mainbus0: MB86907 @ 170 MHz, on-chip FPU
cpu0: 16K instruction (32 b/l), 16K data (32 b/l), 512K external (32 b/l) DVMA coherent cache enabled
obio0 at mainbus0
clock0 at obio0 addr 0x71200000: mk48t08 (eeprom)
timer0 at obio0 addr 0x71d00000 delay constant 82
zs0 at obio0 addr 0x71100000 pri 12, softpri 6
zstty0 at zs0 channel 0: console
zstty1 at zs0 channel 1
zs1 at obio0 addr 0x71000000 pri 12, softpri 6
zskbd0 at zs1 channel 0: no keyboard
zstty2 at zs1 channel 1: mouse
slavioconfig at obio0 addr 0x71800000 not configured
auxreg0 at obio0 addr 0x71900000
power0 at obio0 addr 0x71910000
fdc0 at obio0 addr 0x71400000 pri 11, softpri 4: chip 82077
iommu0 at mainbus0 addr 0x10000000: version 0x5/0x0, page-size 4096, range 64MB
sbus0 at iommu0: 21.250 MHz
dma0 at sbus0 slot 5 offset 0x8400000: rev 2
esp0 at dma0 offset 0x8800000 pri 4: ESP200, 40MHz
scsibus0 at esp0: 8 targets, initiator 7
cd0 at scsibus0 targ 2 lun 0: <MATSHITA, CD-ROM CR-504, ST23> SCSI2 5/cdrom removable
sd0 at scsibus0 targ 3 lun 0: <IBM, DCAS32160SUN2.1G, S60B> SCSI2 0/direct fixed serial.IBM_DCAS32160SUN2.1GF2583160_
sd0: 2063MB, 512 bytes/sector, 4226725 sectors
"SUNW,bpp" at sbus0 slot 5 offset 0xc800000 not configured
ledma0 at sbus0 slot 5 offset 0x8400010: rev 2
le0 at ledma0 offset 0x8c00000 pri 6: address 08:00:20:89:d9:b5
le0: 16 receive buffers, 4 transmit buffers
"SUNW,CS4231" at sbus0 class serial slot 4 offset 0xc000000 not configured
"power-management" at sbus0 slot 4 offset 0xa000000 not configured
cgsix0 at sbus0 slot 3 offset 0x0 pri 9: SUNW,501-2325, 1152x900, rev 11
wsdisplay0 at cgsix0
wsdisplay0: screen 0 added (std, sun emulation)
bootpath: /iommu@0,10000000/sbus@0,10001000/espdma@5,8400000/esp@5,8800000/sd@3,0
root on rd0a swap on rd0b dump on rd0b
erase ^?, werase ^W, kill ^U, intr ^C, status ^T

Welcome to the OpenBSD/sparc 5.1 installation program.
(I)nstall, (U)pgrade or (S)hell? I
At any prompt except password prompts you can escape to a shell by
typing '!'. Default answers are shown in []'s and are selected by
pressing RETURN.  You can exit this program at any time by pressing
Control-C, but this can leave your system in an inconsistent state.

Terminal type? [sun] 
System hostname? (short form, e.g. 'foo') warbird

Available network interfaces are: le0.
Which one do you wish to configure? (or 'done') [le0] 
IPv4 address for le0? (or 'dhcp' or 'none') [dhcp] 
Issuing hostname-associated DHCP request for le0.
DHCPDISCOVER on le0 to 255.255.255.255 port 67 interval 1
DHCPOFFER from 10.0.0.27 (00:00:24:c9:d4:98)
DHCPREQUEST on le0 to 255.255.255.255 port 67
DHCPACK from 10.0.0.27 (00:00:24:c9:d4:98)
bound to 10.0.0.25 -- renewal in 21600 seconds.
Available network interfaces are: le0.
Which one do you wish to configure? (or 'done') [done]