Re: Vendor specific DHCP option codes
Kaya Saman <[email protected]>
| Newsgroups | gmane.os.openbsd.sparc |
|---|---|
| Message-ID | <[email protected]> |
On 11/14/2012 12:09 AM, Justin Haynes wrote: >> option option-66 0A:0A:0A:0A ? Thanks for the response! I tried this using my subnet but the dhcp service failed to start with the log claiming: option-66 no such dhcp option? > Sent from my iPhone > > On Nov 13, 2012, at 5:59 PM, Kaya Saman <[email protected]> wrote: > >> Hi, >> >> I'm trying to migrate the dhcp configuration from within a Cisco router to OpenBSD. So far everything has gone really smoothly and basic things are working fine. >> >> What I'm currently quite stuck with however is vendor specific option codes.... I have a few Polycom IP phones which I used a handful of codes with: >> >> 4, 7, 42, 66, 150, 151, 160 >> >> >> How do I add these into the dhcpd.conf file? >> >> Currently reading through the "dhcp-options" man page it suggests to add: >> >> option option-66 <HEX of IP address separated by :> >> >> Unfortunately the syntax was wrong and produced an error. >> >> >> How would I be able to add for example: >> >> option 66 ip 10.10.10.10 >> >> ?? >> >> >> So far I specified: >> >> subnet 10.10.10.0 netmask 255.255.255.192{ >> option routers 10.10.10.1; >> range 10.10.10.2 10.10.10.62; >> } >> >> >> which is all fine bar the options..... unfortunately the web wasn't any help as some places claimed to add: >> >> option option-66 string; >> >> to the top of the file then add the rest in the "pool" this however also produced an error so I am out of ideas. >> >> >> >> Regards, >> >> Kaya >> Regards, Kaya