xenocara build fails on 5.5-stable

Maurice Janssen <[email protected]>
Newsgroups gmane.os.openbsd.sparc
Message-ID <[email protected]>
Hi,

I'm trying to build xenocara on a sparcstation running 5.5-stable (dmesg
below).  During make build, I get the following error:

===> app/editres
cd /usr/xenocara/app/editres && exec make  -f Makefile.bsd-wrapper cleandir
cd /usr/xenocara/app/editres && exec make  -f Makefile.bsd-wrapper depend
no dependencies here yet
cd /usr/xenocara/app/editres && exec make  -f Makefile.bsd-wrapper all
PKG_CONFIG_LIBDIR="/usr/X11R6/lib/pkgconfig"  CONFIG_SITE=/usr/xenocara/etc/config.site  CFLAGS="-O2 -pipe"  MAKE="make" PATH=/bin:/sbin:/usr/bin:/usr/sbin:/usr/X11R6/bin  exec sh /usr/xenocara/app/editres/configure --prefix=/usr/X11R6  --sysconfdir=/etc  --mandir=/usr/X11R6/man  --cache-file=/usr/xobj/xorg-config.cache.sparc  --disable-silent-rules
configure: loading site script /usr/xenocara/etc/config.site
configure: loading cache /usr/xobj/xorg-config.cache.sparc
checking for a BSD-compatible install... (cached) /usr/bin/install -p
checking whether build environment is sane... configure: error: newly created file is older than distributed files!
Check your system clock
*** Error 1 in app/editres (/usr/X11R6/share/mk/bsd.xorg.mk:179 'config.status')
*** Error 1 in app/editres (/usr/X11R6/share/mk/bsd.xorg.mk:211 'build')
*** Error 1 in app (<bsd.subdir.mk>:48 'build')
*** Error 1 in . (<bsd.subdir.mk>:48 'realbuild')
*** Error 1 in /usr/xenocara (Makefile:36 'build')

When I start over, the build fails in the same way (configure: error:
newly created file is older than distributed files!), but at another point
during the build.
The xenocara source is mounted from an NFS server, both have their clocks
syncrhonised from a set of local NTP servers, so their time is within a
few ms from each other.
Other systems (e.g. sparc64 or hppa) using the same NFS server have no
problem.  A similar sparcstation-5 running 5.4-stable also works fine.
The computer with the problem was running 5.3-stable until May 1st and
also worked fine when building xenocara.

What could be the problem here?

Thanks for any hints,
Maurice


OpenBSD 5.5 (GENERIC) #0: Fri May  2 00:38:14 CEST 2014
    [email protected]:/usr/src/sys/arch/sparc/compile/GENERIC
real mem = 268025856 (255MB)
avail mem = 258617344 (246MB)
mainbus0 at root: SUNW,SPARCstation-5
cpu0 at mainbus0: MB86907 @ 170 MHz, on-chip FPU
cpu0: 16K instruction (32 b/l), 16K data (32 b/l), 512K external (32 b/l) DVMA coherent cache enabled
obio0 at mainbus0
clock0 at obio0 addr 0x71200000: mk48t08 (eeprom)
timer0 at obio0 addr 0x71d00000: delay constant 82, frequency 2000000 Hz
zs0 at obio0 addr 0x71100000 pri 12, softpri 6
zstty0 at zs0 channel 0: console
zstty1 at zs0 channel 1
zs1 at obio0 addr 0x71000000 pri 12, softpri 6
zskbd0 at zs1 channel 0: no keyboard
zsms0 at zs1 channel 1
wsmouse0 at zsms0 mux 0
slavioconfig at obio0 addr 0x71800000 not configured
auxreg0 at obio0 addr 0x71900000
power0 at obio0 addr 0x71910000
fdc0 at obio0 addr 0x71400000 pri 11, softpri 4: chip 82077
iommu0 at mainbus0 addr 0x10000000: version 0x5/0x0, page-size 4096, range 64MB
sbus0 at iommu0: 21.250 MHz
dma0 at sbus0 slot 5 offset 0x8400000: rev 2
esp0 at dma0 offset 0x8800000 pri 4: ESP200, 40MHz
scsibus0 at esp0: 8 targets, initiator 7
sd0 at scsibus0 targ 3 lun 0: <QUANTUM, ATLAS_V__9_SCA, 0230> SCSI3 0/direct fixed eui.00e09e00244a5767
sd0: 8755MB, 512 bytes/sector, 17930694 sectors
cd0 at scsibus0 targ 6 lun 0: <MDI, SECD12X, 3136> SCSI2 5/cdrom removable
bpp0 at sbus0 slot 5 offset 0xc800000: DMA2
ledma0 at sbus0 slot 5 offset 0x8400010: rev 2
le0 at ledma0 offset 0x8c00000 pri 6: address 08:00:20:90:5a:7f
le0: 16 receive buffers, 4 transmit buffers
audiocs0 at sbus0 slot 4 offset 0xc000000 pri 9
audio0 at audiocs0
"power-management" at sbus0 slot 4 offset 0xa000000 not configured
hme0 at sbus0 slot 2 offset 0x8c00000 pri 7: address 08:00:20:90:5a:7f rev 34
nsphy0 at hme0 phy 1: DP83840 10/100 PHY, rev. 0
cgsix0 at sbus0 slot 3 offset 0x0 pri 9: SUNW,501-2325, 1152x900, rev 11
wsdisplay0 at cgsix0 mux 1
wsdisplay0: screen 0 added (std, sun emulation)
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
bootpath: /iommu@0,10000000/sbus@0,10001000/espdma@5,8400000/esp@5,8800000/sd@3,0
root on sd0a (e0c1796b953eaf8e.a) swap on sd0b dump on sd0b
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.