Re: Hardware fault on M3000

> Is this specific to the M3000? Because I run 6.1 on a M4000 without issue
> which is nearly identical architecture wise.
> IIRC if you do a full xscf reset and get to the initial user setup dialog
> you can add field engineer status to any account.

I was able to assign the fieldeng and mode privileges to my user
after performing a full reset of the XSCF, but trying to use
enableservice requires a service password from Oracle support.

On the M3000, addboard and deleteboard are not supported, and
replacefru only allows me to replace fans and PSUs -- I guess
because there is only one system board and it's not considered
field-replaceable.