Re: LDOM commands return Device not configured

Hey Andrew, thanks for the reply.

> I found it was necessary to use OBSD 6.3 or earlier to create LDOM config=
s on my T1000
> You will need to restore to the factory-default config first if this is t=
he case.

I gave OpenBSD 6.3 a try, but I got the same results as with 6.7:

# ldomctl dump
ldomctl: cannot open /dev/hvctl: Device not configured
# ldomctl list
ldomctl: cannot open /dev/hvctl: Device not configured
# uname -a
OpenBSD terminator.local 6.3 GENERIC.MP#486 sparc64

Do you know of a more low-level way to read the contents of the
NVRAM? I've tried to reset it a few times but it doesn't seem
to have have an effect.

I'm also curious about how to probe the device for the presence
of the sun4v hypervisor hardware- it doesn't report any faults
from extended POST so I'm sure it's there, just not being
recognized.