Re: OpenBSD 3.3 on old KA650 qbus mscp machine???

On Mon, Apr 07, 2003 at 10:23:24PM -0400, [email protected] wrote:
> Offhand do you have a table of the switch settings on the
> delqa?  Mine are set on on on on.  The show qbus
> lists it at 774440, which should be the first controller?

AOL says I'm not allowed to talk to you directly, so I'm going to
bounce this off the list.

This is a snippit from the DELQA-plus manual. If your card is
not a DELQA-YM you can ignore dip switch 5:

Switch  Setting Meaning
S1      CLOSED  This is the first DELQA-PLUS device; this device 
                resides at Q-bus address 1777 4440 (octal).
        OPEN    This is the second DELQA-PLUS device; this device 
                resides at Q-bus address 1777 4460 (octal).
S2              (Reserved.)
S3      CLOSED  Selects DELQA-normal mode
        OPEN    Selects DEQNA-lock mode (Board can operate in DEQNA
                mode only, not in DELQA modes.)
S4      CLOSED  HIT (host inactivity timer) initially disabled
        OPEN    HIT timer initially enabled
S5      CLOSED  T-mode enabled (Board can operate as DELQA-normal
		board or DELQA-T board.)
        OPEN    T-mode disabeld (Board can operate only as a 
                DELQA-normal board or DEQNA board.)

Also, try booting the "bsd" kernel from the snapshots dir. Perhaps
there is something wrong with the floppy.

/Hugh

> 
> Thanks
> 
> Bob