"No disks found" error when I install OpenBSD 4.0 on a Dell Server with Adaptec SATA RAID 2610SA controller

I am installing an OpenBSD 4.0 from bootable setup CD on a Dell
PowerEdge 750. I've created a RAID 1 with two SATA hard disks attached
to an Adaptec SATA RAID 2610SA controller.

However, when I try to install, I get message "No disks found".  The
funny thing is when I boot the server with OpenBSD 3.6 CD I can get the
hard disk sd0.



Does OpenBSD 4.0 support Adaptec SATA RAID 2610SA controller? If yes,
why cannot load driver of that?



Thanks,



Wilson J. Liu



Network Systems Administrator





  23 Lesmill Road, Suite 404

  Toronto, Ontario M3B 3P6, Canada

  Tel:  (416) 445-7162 x 230    Fax: (416) 445-2341

  e-mail:     [email protected]

  website:   www.bsharp.com <http://www.bsharp.com/>
-----------------------

Information contained in this e-mail message is intended only for the
use of the individual to whom it is addressed and is private and
confidential. If you are not the intended recipient, or the employee or
agent responsible for delivering this message to the intended recipient,
any dissemination, distribution or copying of this communication is
strictly prohibited. If you have received this message in error, please
kindly destroy it and notify the sender immediately by reply e-mail.
Thank you for your cooperation.
------------------------

[demime 1.01d removed an attachment of type image/jpeg which had a name of image001.jpg]