Re: Adding OpenBSD to Symantec GivingStation...
"J.C. Roberts" <[email protected]>
| Newsgroups | gmane.os.openbsd.www |
|---|---|
| Organization | DesignTools |
| Message-ID | <[email protected]> |
On Wednesday 25 April 2007 06:22, Amarendra Godbole wrote: > > > Oh! Thanks for the reminder - I have looked up this information, > > > and assume that it is correct. :) > > > > > > -Amarendra > > > > It would be wise (and polite) to contact Theo directly about this > > topic before you do anything. > > I did contact Theo on 22-March-2007, but never heard from him. It is > possible that my mail was lost in the heap of email he gets, or he is > too busy, so I waited for a reply. After a month, when I did not have > a reply, I sent an email to www@ finally, hoping to hear from > *someone* at OpenBSD. :) > > Though I have the information from whois, I won't be doing anything, > unless and until I hear from someone at OpenBSD. Thanks! > > -Amarendra First of all, I do not represent the project in any way and I'm not really associated with it. I'm just a long time end user -i.e. I'm no one special. I'm subscribed to www@ only because it's the right list to post diffs for the www branch. ;-) The only person you should really talk to is Theo. Other people you might want to contact are Bob Beck and Jason George but Theo is really the person you need to get the OK from. Make sure you use the right email address for Theo. Theo de Raadt: [email protected] In his defense, Theo does travel, hike and go mountain biking, so you may have tried contacting him when he's off in some remote place (and returns to a mountain of email). This is what you need to realize: 0.) You may have used the wrong email address for Theo or got stuck in his spam filters. 1.) Your timing is very bad. -too close to the May 1 release among other reasons. 2.) If you get no response, there is probably a good reason for the lack of response and you might want to try your request again in a few months, since situations tend to change. ;-) 3.) Please, do not bring up the issue on the main misc@ mailing list. It will only cause yet another pointless discussion. Kind Regards, JCR