Dual Head on SPACStation 4

It may seem a bit of a strech but I'm going for dualhead SPARCStation 4.
I have the "onboard tcx" and I added a 8bit cgsix. As you can see from
the "messages" file, both are found at boot time but only the cgsix is
being attached to a device. If I remove the cgsix then the tcx works
fine. How can I get both to be attached?



I have tried (found this hint in some man page somewhere):

cd /dev

./MAKEDEV fd1

reboot



cd /dev

./MAKEDEV fd

reboot



cd /dev

./MAKEDEV cgsix

reboot



cd /dev

./MAKEDEV tcx

reboot



Non of this helped.



MESSAGES FILE:

May  4 12:54:21 sundog syslogd: restart
May  4 12:54:21 sundog /bsd: OpenBSD 3.1 (GENERIC) #27: Wed Apr 17
13:52:53 MDT 2002
May  4 12:54:22 sundog /bsd:
[email protected]:/usr/src/sys/arch/sparc/compile/GENERIC
May  4 12:54:22 sundog /bsd: real mem = 167424000
May  4 12:54:22 sundog /bsd: avail mem = 152010752
May  4 12:54:22 sundog /bsd: using 200 buffers containing 8368128 bytes
of memory
May  4 12:54:22 sundog /bsd: bootpath:
/iommu@0,10000000/sbus@0,10001000/espdma@4,8400000/esp@4,8800000/sd@3,0
May  4 12:54:22 sundog /bsd: mainbus0 (root): SUNW,SPARCstation-4
May  4 12:54:22 sundog /bsd: cpu0 at mainbus0: MB86904 @ 110 MHz,
on-chip FPU
May  4 12:54:22 sundog /bsd: cpu0: 16K instruction (32 b/l), 8K data (16
b/l) cache enabled
May  4 12:54:22 sundog /bsd: obio0 at mainbus0
May  4 12:54:22 sundog /bsd: clock0 at obio0 addr 0x71200000: mk48t08
(eeprom)
May  4 12:54:22 sundog /bsd: timer0 at obio0 addr 0x71d00000 delay
constant 52
May  4 12:54:22 sundog /bsd: zs0 at obio0 addr 0x71100000 pri 12,
softpri 6
May  4 12:54:22 sundog /bsd: zs1 at obio0 addr 0x71000000 pri 12,
softpri 6
May  4 12:54:23 sundog /bsd: slavioconfig at obio0 addr 0x71800000 not
configured
May  4 12:54:23 sundog /bsd: auxreg0 at obio0 addr 0x71900000
May  4 12:54:23 sundog /bsd: power0 at obio0 addr 0x71910000
May  4 12:54:23 sundog /bsd: fdc0 at obio0 addr 0x71400000 pri 11,
softpri 4: chip 82077
May  4 12:54:23 sundog /bsd: fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head,
18 sec
May  4 12:54:23 sundog /bsd: iommu0 at mainbus0 addr 0x10000000: version
0x4/0x0, page-size 4096, range 64MB
May  4 12:54:23 sundog /bsd: sbus0 at iommu0: clock = 22 MHz
May  4 12:54:23 sundog /bsd: dma0 at sbus0 slot 4 offset 0x8400000: rev
2
May  4 12:54:23 sundog /bsd: esp0 at dma0 offset 0x8800000 pri 4:
ESP200, 40MHz, SCSI ID 7
May  4 12:54:23 sundog /bsd: scsibus0 at esp0: 8 targets
May  4 12:54:23 sundog /bsd: sd0 at scsibus0 targ 0 lun 0: <SEAGATE,
ST410800N, 0021> SCSI2 0/direct fixed
May  4 12:54:23 sundog /bsd: sd0: 8669MB, 4926 cyl, 27 head, 133 sec,
512 bytes/sec, 17755614 sec total
May  4 12:54:23 sundog /bsd: sd1 at scsibus0 targ 3 lun 0: <QUANTUM,
FB1080J SUN1.05, 630E> SCSI2 0/direct fixed
May  4 12:54:23 sundog /bsd: sd1: 1042MB, 3835 cyl, 4 head, 139 sec, 512
bytes/sec, 2134305 sec total
May  4 12:54:23 sundog /bsd: bpp0 at sbus0 slot 4 offset 0xc800000: DMA2
May  4 12:54:24 sundog /bsd: ledma0 at sbus0 slot 4 offset 0x8400010:
rev 2
May  4 12:54:24 sundog /bsd: le0 at ledma0 offset 0x8c00000 pri 6:
address 08:00:20:7d:d0:e2
May  4 12:54:24 sundog /bsd: le0: 16 receive buffers, 4 transmit buffers
May  4 12:54:24 sundog /bsd: cgsix0 at sbus0 slot 0 offset 0x0:
SUNW,501-2253, 1152 x 900, rev 11 (console)
May  4 12:54:24 sundog /bsd: cgsix0: attached to /dev/fb
May  4 12:54:24 sundog /bsd: tcx0 at sbus0 slot 2 offset 0x800000:
SUNW,tcx, 1024 x 768, id 0, rev 2, sense 0
May  4 12:54:24 sundog /bsd: power-management at sbus0 slot 3 offset
0xa000000 not configured
May  4 12:54:24 sundog /bsd: root on sd1a
May  4 12:54:24 sundog /bsd: kbd: type = 4, layout = 0x21
May  4 12:54:24 sundog /bsd: rootdev=0x710 rrootdev=0x1110 rawdev=0x1112
May  4 12:54:24 sundog savecore: no core dump