Re: network configuration help -- using ncutil

> On reboot:
> 
> 1. Does the method remain Manual?
> 2. What shows up as ip-address?

The stuff I quoted is from immediately after a reboot.  It stays the same 
through multiple reboots.  I have to configure the ethernet card manually with 
ifconfig.

> > /
> >   current-location home
> > /home
> >   service-order  0    Built-in Ethernet
> > /home/Built-in Ethernet
> >   inactive false
> > /home/Built-in Ethernet/Ethernet
> >   inactive false
> > /home/Built-in Ethernet/Interface
> >   inactive false
> >   device-name en0
> >   hardware Ethernet
> >   type Ethernet
> >   sub-type
> > /home/Built-in Ethernet/IPv4
> >   method Manual
> >   ip-address
> >  10.0.0.12
> >   subnet-mask
> >  255.0.0.0
> >   router 10.0.0.9
> > /home/Built-in Ethernet/PPP
>
> > When I do "ifconfig" I get
> > lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
> >         inet6 ::1 prefixlen 128
> >         inet6 fe80::1 prefixlen 64 scopeid 0x1
> >         inet 127.0.0.1 netmask 0xff000000
> > gif0: flags=8010<POINTOPOINT,MULTICAST> mtu 1280
> > stf0: flags=0<> mtu 1280
> > en0: flags=8822<BROADCAST,SMART,SIMPLEX,MULTICAST> mtu 1500
> >         tunnel inet  -->
> >         ether 00:50:e4:16:10:34
> >         media: autoselect (<unknown type>)
> >         supported media: none autoselect 10baseT/UTP <half-duplex> 
> > 10baseT/UTP
> > <
> > full-duplex> 100baseTX <half-duplex> 100baseTX <full-duplex>