Qt3 and QNX6.2NC Grrr....

If you have some time yourself it should actually not be too hard
recompiling Qt3/X11 under QNX 6.2NC. I think if you follow the directions in
the readme file from Qt3-qnx.tar.gz at openqnx. Under 6.2 it is probably
even easier than it was under 6.1 - therefore you might not have to do all
the steps described in the readme file.
--
Jens

-----Original Message-----
From: Johan CARDON [mailto:johan.cardon-wMUr/[email protected]]
Sent: Thursday, June 20, 2002 12:00 PM
To: openqnx
Subject: Re: [Openqnx-developer] Qt3 and QNX6.2NC Grrr....


Le Jeudi 20 Juin 2002 17:42, vous avez écrit :
> Most likely because of the C++ changes.
> 6.1 uses Dinkum and 6.2NC uses GNU.
> I will have to re-port the Qt to 6.2NC GNU C++ when I have "free"
> time or "paid" time.
>
Yes, I understand the problem. What is the Trolltech position ? Do they just

say (like me) : Thank you Mr Liu, good job !

Before mail you, I tested to compile Qt3.0.4 with your recommendation but
get 
errors at link stage so I decided to continue using your binaries port. But
I 
will be patient and test the 6.2 qnxbasesmp.ifs under 6.1

-- 
				Institut Albert Bonniot
Johan CARDON			Faculté de Medecine de Grenoble
Laboratoire IMAG/TIMC/GMCAO 	Domaine de la Merci
Tel: +33 (0)4 76 54 95 05	38706 La Tronche Cedex


-------------------------------------------------------
                   Bringing you mounds of caffeinated joy
                   >>>     http://thinkgeek.com/sf    <<<