Re: prob howto install driver

Hallo,

I get a BSOD, if install ethernetdriver el90xnd5.sys.
HW seen to be ok. (tested on knoppix)

Whats going wrong?

Heiko

details:
- ReactOS 0.4-SVN (Build 20100711-r47998)

- install driver [1] [2]
  wget ftp://ftp.3com.com/pub/nic/3c90x/3c90x1.exe
  dosbox> 3c90x1.exe
  knoppix # scp $src/EL90XND5.SY_ $rosdir/TEMP
  ros> cd \TEMP
  ros> expand EL90XND5.SY_ el90xnd5.sys
  ros> copy el90xnd5.sys %windir%\system32
  ## hardwareinstaller will this use as TODO.

- ros: hardwareinstallation detected a new device:
  hardwareinstallation
    Ethenet controller
    [x] treiber von einer bestimmten Pos. installieren:
    [x] diesen Pfad ebenfalls durchsuchen: c:\temp

   Card seen recognized  (print "3com 100Mbit" for 0.01s)
    -> bluescreen:

    A problem has been detected...
      Stop: 0x000001E (0cc0000005,0xf93c2f01,0xf93e9658,0x000000)
      el90xnd5.sys - Address F93c2f01 base at f93b000. dtaStamp 3b535836


- debug.log: IRQ11 fail


I cannot get debuginfo over serial interface.
Therefore i attached debug.log (part) only.

 $ egrep -i "^00|hal|err|ether|irq|3c" /var/tmp/debug.log > ros.deb.log-100723.3com.part

Does exist another way to install network-driver?
Howto add timestamp to debug.log?


[1] http://www.reactos.org/wiki/Supported_Hardware/Network_cards
   - supported HW
[2] http://www.reactos.org/archives/public/ros-general/2010-June/002586.html
   - minihowto (concept)

_______________________________________________
Ros-general mailing list
[email protected]
http://www.reactos.org/mailman/listinfo/ros-general