Tru64 4.0g with fiber channel storage
Howard Arnold <[email protected]>
| Newsgroups | gmane.os.tru64.managers |
|---|---|
| Message-ID | <[email protected]> |
I haven't work on a 4.0g system in awhile and then when I did they were mostly scsi based so excuses me if this sounds like a dumb question. Does 4.0g support multibus fail over? I have a standalone ES40 with two KGPSA-CA's connected to two Compaq Storagework 16 EL's connected to an dual controller HSG80. The HSG80 is set up as transparent failover and not multibus. I have one emx controller going to one switch and the other emx controller going to the other switch just like I have set up before on 5.1b systems. I started running a disk exerciser and then pulled emx0, but the disk exerciser failed rather than failing over. Is this normal for 4.0g? Could it be because I don't have my HSG80's set up in multibus failover? I haven't installed any patches yet so if that will fix this I'll try it. It looks like emx1 is a separate bus from emx0 so to me it looks like 4.0g doesn't support failover, but I'm just trying to confirm. Howard Arnold Consultant Engineer Email: [email protected] Phone: (603)685-6060 ext. 206