Another 4.0g with fiber channel question

Another hopefully quick question about adding a HSG80 to an existing 4.0g
system.

The system has been up for a year and in that time there have been a number
of HSG80's added and removed from the system. All of this was in the
emx.info file and when I added my new HSG80 to the system it was added as
target ID 9 under emx0 and emx1. At the present time I can't see any disks
under the new HSG80 and I was wondering if it is because of the target ID in
the emx.info file. This is above the scsi range of 0-7.

I believe that if I reboot the machine than the emx.info file would be
cleanup of all the old HSG80's. What I would like to know is there a way
that I can move this new HSG80 into a lower target without rebooting. I have
look at emxmgr, but if I read the man page right there still would need to
be a reboot.

Has anyone else run into this?

Thanks,

Howard Arnold
Consultant Engineer
Email: [email protected]
Phone: (603)685-6060 ext. 206