KZPEA and DS20E

Thomas Edward Kempster <[email protected]>
Newsgroups gmane.os.tru64.managers
Message-ID <[email protected]> 
I am trying to install a KZPEA and need to run the "run bios" command at
the >>> prompt to change the termination. I can "show bios" and both
channels show but when I "run bios pka0" the system runs and then
returns to the prompt. I have tried Control A despite not being prompted
but that does not help. I have connected a serial monitor and removed
the graphic card but none of this has helped. 

Can anyone help please?

Regards,

Tom Kempster

-- 
http://www.fastmail.fm - IMAP accessible web-mail
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.