DS20E Failure at Power up
Thomas Edward Kempster <[email protected]>
| Newsgroups | gmane.os.tru64.managers |
|---|---|
| Message-ID | <[email protected]> |
This morning I powered down a DS20E to move the PCI cards around, the KZPEA was in hose 1 after tests and I wanted it put back into a hose 0 slot. On power up I noticed that although the green Power LED came on, after a while the yellow LEDs briefly flashed, I was then left with just the green LED on. I can get no output on the console and suspect the system did not power up completely. Normally the yellow LEDs stay on for some time whilst testing. After that the green Power LED stays lit if all is well. I have a horrible feeling that this is a hardware fault but any suggestions would be very welcome. I have removed all PCI cards one by one without clearing the problem. Regards, Tom Kempster -- http://www.fastmail.fm - And now for something completely different