Summary: Problem with DS-KZPCC-AC and ES40/Tru64 5.1B-PK3

I have to add the following lines to /sys/conf/<HOSTNAME>

bus             i2o0       at *
controller      i2o_bs0    at i2o0      slot  0
device disk     ri0        at i2o_bs0   drive     0
controller      i2o_bs1    at i2o0      slot  0
device disk     ri1        at i2o_bs1   drive     1

config_driver pza

and rebuild a new kernel with
# doconfig -c <HOSTNAME>

Copy it to / and reboot.


Many thanks for all replies.




>Betreff: Problem with DS-KZPCC-AC and ES40/Tru64 5.1B-PK3
>
>Hi Managers,
>
>we have an ES40 (2 x 833Mhz) with 4 GB Ram, Tru64 5.1B-PK3, Alpha Firmware 6.6-19. I installed a DS-KZPCC-AC (Firmware CQ17) and connected it to the internal drive cage DS-610-6D. The 3 x HP 72 GB 10k Hotplug SCSI Drives are configured as a RAIS 5. But neither in /devices/disk nor in the disk-app in CDE are entries of the RAID-Volume.
>
>On console the volume and the controller are shown as follows:
>
>dza517.0.0.2004.1		DZA517 (BSA)
>pza0.0.0.2004.1			I2OA0
>
>
>Any ideas why the volume doesn't appear? Normally dsfmgr have to create the /dev entries at boot time, right? TIA.
>
>
>Best regards,
>Thomas Hummel
>