SUMMARY: AS800 can't see disks on RA3000

SUMMARY:

As I expected, it was something simple. I needed to run doconfig so the 
new adapter would get loaded at boot. After that, piece of cake!

Thanks to Raul Sossa Sossa for quick response!

Cheers!
--------------------------------------------------------------------------------------------------------------
I have a new (to me) RA3000 with one mirror set created. The unit was 
attached to an AlphaServer 400 with no other controllers in it. That 
server booted from rz0 internal, and the mirror set showed up as rz8. I 
built file systems, added an informix database and pretty much tested it 
out for a couple of days. I shut everything down, connected the ra3000 to 
a new controller with a y cable and external terminator in my AlphaServer 
800 (already has a kz  adapter connected to an hsz40, and a mylex for 
booting). At the srm prompt, is see the new controller as pkc0.5.0.14.0, 
and the disk as dkc0.0.0.14.0

Problem: when I boot unix ( 4.0g same as the AlphaServer400 ), the device 
special files aren't being created, and scsimgr -scan_all doesn't find the 

disks either.  The mylex drives show up as re0, the hsz40 drives are rz128 

and rz129. Its been years since I've had to mess with this stuff....


TIA

Ralf


Email: ralf.borowski.at.abitibibowater.com