RE: 7 or 8 inches sir? (Or madam) :-)

> So what do I have to do to fit a 7 or 8 inch rim to the rear of my 
> non-superlight chassis?

I've only heard of the 8.5 inch R500 rims fouling the roll bar not 7 inch.
But Dave J reckons that even these will fit if you reverse the link from the
outside of the roll bar blade to the inside.  Or of course you can go for
the Freestyle (still want to call them Juno....) adjustable rear bar which
is underslung but forward facing, it mounts to the flat plates in the
corners below the fuel tank.


****************************************************************************
The information contained in this email is intended only for the use of the intended recipient at the email address to which it has been addressed. If the reader of this message is not an intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination or copying of the message or associated attachments is strictly prohibited.

If you have received this email in error, please contact the sender by return email or call 01793 877777 and ask for the sender and then delete it immediately from your system.Please note that neither RWEInnogy nor the sender accepts any responsibility for viruses and it is your responsibility to scan attachments (if any).
*****************************************************************************
-------------------------------------------------
To manage your subscription options visit :-
http://mailman.se7ens.net/mailman/listinfo/sevens