RE: 7 or 8 inches sir? (Or madam) :-)

> How easy is the underslung one to fit? Requires a visit to Arch? 
> Likelihood that the mods, if any, can be done here in Finland easily?

Yeah should be a piece of p*ss.  I looked into doing it before I talked to
Freestyle.  There are a pair of small tubes brazed through the lower chassis
rails just behind where the A frame mounts to the chassis.  These tubes take
a couple of bolts that attach the alloy blocks to the chassis.  Only problem
is where they are along the rail.  But it's not critical for an ARB and if
you have the bar offered up to the chassis it'll be pretty obvious where it
should go.  Plus I'm sure some kind lister could measure his chassis and let
you know.


****************************************************************************
The information contained in this email is intended only for the use of the intended recipient at the email address to which it has been addressed. If the reader of this message is not an intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination or copying of the message or associated attachments is strictly prohibited.

If you have received this email in error, please contact the sender by return email or call 01793 877777 and ask for the sender and then delete it immediately from your system.Please note that neither RWEInnogy nor the sender accepts any responsibility for viruses and it is your responsibility to scan attachments (if any).
*****************************************************************************
-------------------------------------------------
To manage your subscription options visit :-
http://mailman.se7ens.net/mailman/listinfo/sevens