RE: Calipers

> I have a pair of cast iron 4 pot calipers which I am overhauling and was 
> thinking of  splitting the calipers so that I could get at the bores to
make sure 
> that they are clean.
> Any reason I should not do this or any problems putting them back together

> again?
 
Nope, just normal rules like keep everything clean on assembly, dip seals in
clean brake fluid before refitting.  Are they Princess calipers?  If so
there are repair kits available with new seals and bolts in. 


****************************************************************************
The information contained in this email is intended only for the use of the intended recipient at the email address to which it has been addressed. If the reader of this message is not an intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination or copying of the message or associated attachments is strictly prohibited.

If you have received this email in error, please contact the sender by return email or call 01793 877777 and ask for the sender and then delete it immediately from your system.   Please note that neither Innogy nor the sender accepts any responsibility for viruses and it is your responsibility to scan attachments (if any).
*****************************************************************************
-------------------------------------------------
To manage your subscription options visit :-
http://mailman.se7ens.net/mailman/listinfo/sevens