RE: Calipers

> No they are Cossie 4 pots and I have a set of seals but no bolts so may
have 
> to think about getting some new ones. How do you seal them when they are 
> assembled?

The princess calipers have a small square section o ring type seal that sits
in a recess on one half of the body around the fluid port between the two
halves.  No other sealing required as the only fluid is through this port.

I just took the old bolts in to a fastener place and got unbrako allen set
screws the relevant thread and length.

When I did my princess calipers I was converting them for use with vented
discs on an escort so I had to make up a spacer plate, fit a second seal and
use longer bolts.  Took bl**dy ages to cut the spacer plates out of 10mm
steel with an angle grinder then about 3 months later Rally Design started
selling kits to do it.  Bummer.


****************************************************************************
The information contained in this email is intended only for the use of the intended recipient at the email address to which it has been addressed. If the reader of this message is not an intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination or copying of the message or associated attachments is strictly prohibited.

If you have received this email in error, please contact the sender by return email or call 01793 877777 and ask for the sender and then delete it immediately from your system.Please note that neither RWEInnogy nor the sender accepts any responsibility for viruses and it is your responsibility to scan attachments (if any).
*****************************************************************************
-------------------------------------------------
To manage your subscription options visit :-
http://mailman.se7ens.net/mailman/listinfo/sevens