Optolinx works with R2

Hey all.
  I figured out that the optolinx does work as an interface for the 
R2. It's quite simple really. All you need is a cable with a 3.5 mm 
stereo plug on one end that will plug into the R2. The other end can 
be just a mono 3.5 mm plug and this will plug into any of the three 
middle jacks on the front of the optolinx labeled A, B, or C. Be 
sure that the 'Ring' of the stereo plug is connected to the 'tip' of 
the mono plug. Also set both of the dip switches on the back of the 
optolinx to the off position (up). While it's not really worth 
buying an optolinx just for the R2 interface (way too expensive), if 
you already have one for some other radio it's kinda cool that it 
works for the R2 as well.








------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/ELTolB/TM
--------------------------------------------------------------------~-> 

Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 
List owner:     [email protected] 
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/icomr2/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/