RE: Duplex Operation

hold down v/m button,after it goes onto menu rotate the dial till offset is
displayed the while holding the func button on the side turn the dial till
you get the step you require, let go of the function button turn the dial to
dup and then while holding the func button again on the side turn the dial
till you get the +dup or -dup for the duplex your looking then press v/m
again and now when you press the monitor on the side you will hear the
selected off set
or simpler, program both channels back to back

cheers
Mike
http://newcastlescan.tripod.com
from Down Under

> -----Original Message-----
> From: astraman12001 [mailto:[email protected]]
> Sent: Wednesday, 2 April 2003 3:37 AM
> To: [email protected]
> Subject: [icomr2] Duplex Operation
>
>
> Hi all,
>
> Sorry if this has been asked before, but I cannot find it in the
> archives.
>
> On an R2 how do you setup duplex operation, i.e. base on 111.000 &
> mobile on 101.000 I'll be doing this on the scanner itself as I
> don't have a programming cable yet.
>
> Cheers
>
> Ian
>
>
>
>
> Post message:   [email protected]
> Subscribe:      [email protected]
> Unsubscribe:    [email protected]
> List owner:     [email protected]
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>




------------------------ Yahoo! Groups Sponsor ---------------------~-->
Save Smiley. Help put Messenger back in the office.
http://us.click.yahoo.com/4PqtEC/anyFAA/i5gGAA/ELTolB/TM
---------------------------------------------------------------------~->

Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 
List owner:     [email protected] 
 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/