Re: Digest Number 1092

----- Original Message ----- 
From: <[email protected]>
To: <[email protected]>
Sent: Saturday, January 01, 2005 6:10 AM
Subject: [icomr2] Digest Number 1092


>
> There are 2 messages in this issue.
>
> Topics in this digest:
>
>       1. Re:  Squelch level  ?
>            From: "Ubbe" <[email protected]>
>       2. Happy New Year
>            From: [email protected]
>
>
> ________________________________________________________________________
> ________________________________________________________________________
>
> Message: 1
>    Date: Fri, 31 Dec 2004 17:54:20 +0100
>    From: "Ubbe" <[email protected]>
> Subject: Re:  Squelch level  ?
>
> AUTO is nothing else than squelchlevel set at 1/2 and is fine most of the
time. In the car it gets a bit too noisy due to all the RF disturbances, and
I usually run the squelch at 1 or 2.
>
> Ubbe.
>
> -----Original Message-----
> From: Adrian Winnard <adrian.winnard-6b45v/[email protected]>
> >
> > On 13 Dec 2004, at 05:45, tones772000 wrote:
> >
> > Hello just wondering does the squelch level matter
> >
>
> Unless you have some special reason to do otherwise, leave it on auto.
> I have found very few occasions where anything else is required.
>
> --
> Adrian
>
>
>
>
> ________________________________________________________________________
> ________________________________________________________________________
>
> Message: 2
>    Date: Fri, 31 Dec 2004 17:32:09 -0600
>    From: [email protected]
> Subject: Happy New Year
>
> IN GOD WE TRUST  ><>
>
>
>The rest we monitor  ;-}
FT



Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 
List owner:     [email protected] 
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/icomr2/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/