Re: R2 and ARC2 problem
"Martin Brown" <[email protected]>
| Newsgroups | gmane.recreation.radio.hardware.icomr2 |
|---|---|
| Message-ID | <000901c30311$ec5003a0$76098351@g1d7z0> |
Hi,
Are you using a commercial interface with the R2 or are you using a
home made one. I had this problem and found out that it was the interface
I made my own) and I could only send to the R2 and not read. It was
actually a problem with the interface wiring which I sorted out and it now
works okay. I can only assume that there is something wrong with your
interface.
Regards
Martin
----- Original Message -----
From: Ray Darr <raydarr0-/[email protected]>
To: <[email protected]>
Sent: Monday, 14 April, 2003 15:35
Subject: [icomr2] R2 and ARC2 problem
> Got my software and key installed.
> I can send to the R2 just fine but when
> I try to read from the R2 to ARC the radio
> says its sending but the software never receives
> any information. The bar in ARC stays empty and at 0..
> anyone had this problem.. I am using a Intel P/3 and Win98..
>
>
>
>
> Post message: [email protected]
> Subscribe: [email protected]
> Unsubscribe: [email protected]
> List owner: [email protected]
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
------------------------ Yahoo! Groups Sponsor ---------------------~-->
Get a FREE REFINANCE QUOTE - click here!
http://us.click.yahoo.com/2CXtTB/ca0FAA/i5gGAA/ELTolB/TM
---------------------------------------------------------------------~->
Post message: [email protected]
Subscribe: [email protected]
Unsubscribe: [email protected]
List owner: [email protected]
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/