Power supply (ac to dc converter for ic-r2)

Anyone ever do this - and if so how exactly is it done?  I am talking 
mainly about hooking up the wires to the brass ends (which ones go to 
which connection)?  Does the positive from the ac converter go to one 
of the + battery nodes and the neg. from the ac go to the same battery 
neg. node?  Any help would be appreciated!

"As far as power goes, I bought a regulated, AC to 3V DC converter, got 
some wooden doweling. Cut and taped the dowels to length as AA batts 
and put brass ends on the dowels and wired the converter wires to it. I 
had to then drill a notch on the side of the battery door for the wire 
to go through. Now I can run it on AC while at home."







------------------------ Yahoo! Groups Sponsor --------------------~--> 
Get to your groups with one click. Know instantly when new email arrives
http://us.click.yahoo.com/.7bhrC/MGxNAA/yQLSAA/ELTolB/TM
--------------------------------------------------------------------~-> 

Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 

 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/icomr2/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/