Re: Anyone know where I can get a programming cable in Canada?

Are you using the SENNS software? If so, I had the same problems using the factory cable. Software has a lot of bugs in it and was abandoned. I ended up using almost strictly for getting the light to stay on permanent.

--- In [email protected], "jrmacgreg" <rmacgregor@...> wrote:
>
> No luck so far finding a connector. What I did find out today.I took >apart the scanner and soldered the wires on pins 2,3 and 5 of a db9 to >the correct points on the CPU PCB. The virtual control worked fine but >transfering frequencies and IDs would not.Also the backup program >would not work. It looks like to do transfers you need the hand >shaking lines for this to work. Oh well I definetly will need a cable. >Too hard to wire to all 9 connects in the scanner. 




------------------------------------

Enjoy the list ! No flames please!
Please Keep it on topic!
 
   Post message:    [email protected] 
   Subscribe:       [email protected] 
   Unsubscribe:     [email protected] 
   List owner:      [email protected] 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/BC245XLT/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/BC245XLT/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/