Re: up to date scanner Freqs and Trunk ID'S
Gig <[email protected]>
| Newsgroups | gmane.recreation.radio.hardware.uniden.bc780xlt |
|---|---|
| Message-ID | <[email protected]> |
I remember back in the day.. when folks vere using 46MHZ for cordless communications they were very popul;ar do the mod and away you go.. I did both just a clip of the diode and you were off to the races Ebay has a few for sale and the prices are quite reasonable too.. certainly not like ny new 996..shgeesch the prices these days At 06:40 10/10/2010, you wrote: > > >They are nice little scanners, I have been >trying to find one, for at least a >few years. Let me know if you  get your hands on any more. > Thanks, > >Bill A. Black >Buford, Ga. > >________________________________ >From: Gig <<mailto:rudebwai%40optonline.net>[email protected]> >To: <mailto:UnidenBC780XLT%40yahoogroups.com>[email protected] >Sent: Sat, October 9, 2010 5:06:04 PM >Subject: Re: [UnidenBC780XLT] up to date scanner Freqs and Trunk ID'S > > >it's the last of 10 i had.... i had them all >boxed up and never used.. i sold them all one >by one over the years... if i decide to sell it >i will keep you in mind... they are a great >scanner if you have all conventional in your area. >thanksAt 10:49 10/9/2010, you wrote: > > > > > >Sir, > >What are you going to do with the Realisticà > >2006, I will be glad to take it off > >your hands? > >à Thanks, > > > >Bill A. Black > >Buford, Ga. > > > >________________________________ > >From: Gig > <<mailto:rudebwai%40optonline.net><mailto:rudebwai%40optonline.net>[email protected]> > >To: > <mailto:UnidenBC780XLT%40yahoogroups.com><mailto:UnidenBC780XLT%40yahoogroups.com>[email protected] > >Sent: Fri, October 8, 2010 7:48:06 AM > >Subject: RE: [UnidenBC780XLT] up to date scanner Freqs and Trunk ID'S > > > >à > >you really know how to hurt a guy dont you..... > >hhahaha i have already gotten the bad? > >news... believe it or not i hardly ever used it > >before it was too complicated to use.... no > >worries i have already enquired about a 996xt. > > > >re banding is a pain in the ass huh? I look > >forward to using the 780 as a conventional > >scanner and finally putting my realistic 2006 out to pasture... > >at lease this way i can buy a new radio. > >thanks for the news... either good or bad! > >At 07:39 10/8/2010, you wrote: > > > > > > > > >I really hate to be the one to break the > news to you, but your 780 will not > > >follow the Suffolk re-banded trunked system (it is, however, still a great > > >scanner for conventional/non-rebanded scanning). > > > > > >Here is a link to the Suffolk trunked data: > > ><<<http://www.radioreference.com/apps/db/?sid > =72>http://www.radioreference.com/apps/db/?sid=72 > >2>http://www.radioreference.com/apps/db/?sid=72 > 2>http://www.radioreference.com/apps/db/?sid=722 > >2 > > > > > > > > >And here for the conventional frequency data: > > ><<<http://www.radioreference.com/apps/db/?cti > d=1>http://www.radioreference.com/apps/db/?ctid=1 > >876>http://www.radioreference.com/apps/db/?ctid > =1876>http://www.radioreference.com/apps/db/?ctid=1876 > >6 > > > > > > > > >Here is a RadioReference wiki page that > explains rebanding and which radios > > >will/will not work: > > ><<<http://wiki.radioreference.com/index.php/R > eba>http://wiki.radioreference.com/index.php/Reba > >nding><http://wiki.radioreference.com/index.php > /Rebanding>http://wiki.radioreference.com/index.php/Rebanding><http://wiki.radioreference.com/index.php/Rebanding>http://wiki.radioreference.com/index.php/Rebanding > >g > > > > > > > > >Good luck. > > > > > >John > > > > > >From: > > ><mailto:UnidenBC780XLT%40yahoogroups.com><mailt > > > o:UnidenBC780XLT%40yahoogroups.com><mailto:UnidenBC780XLT%40yahoogroups.com>[email protected] > > >[mailto:[email protected]] > > >On Behalf Of Gig > > >Sent: Thursday, October 07, 2010 7:42 PM > > >To: > ><mailto:UnidenBC780XLT%40yahoogroups.com><mailt > o:UnidenBC780XLT%40yahoogroups.com><mailto:UnidenBC780XLT%40yahoogroups.com>[email protected] > >m > > >Subject: Re: [UnidenBC780XLT] up to date scanner Freqs and Trunk ID'S > > > > > >Don, > > >thanks for the reply. that was cool of > > >you... I bought proscan for my 780 , but i am > > >having issues with it... I also have an old > > >copy of ARC 780 too hopefully i'll get one of these to work. > > >thanks for the link. > > >At 19:39 10/7/2010, you wrote: > > > > > > > > > > > ><<<<http://www.radioreference.com/>http://w > ww.radioreference.com/>http://www. > > radioreference.com/><http://www.rad>http://www.rad > > > > > >ioreference.com/><<http://www.radioreference.com/>http://www.radioreference.com/>http://www.radioreference.com/ > > > > > > > >Retired Federal Firefighter > > > > > > > >--- On Thu, 10/7/10, giguchan > > > ><<mailto:rudebwai%40optonline.net><mailto:rudeb > > > > wai%40optonline.net><mailto:rudebwai%40optonline.net><mailto:rudebwai%40optonline.net>[email protected] > > ><mailto:rudebwai%40optonline.net> > wrote: > > > > > > > >From: giguchan > ><<mailto:rudebwai%40optonline.net><mailto:rudeb > wai%40optonline.net><mailto:rudebwai%40optonline.net>[email protected] > >t > > ><mailto:rudebwai%40optonline.net> > > > > >Subject: [UnidenBC780XLT] up to date scanner Freqs and Trunk ID'S > > > >To: > ><mailto:UnidenBC780XLT%40yahoogroups.com><mailt > o:UnidenBC780XLT%40yahoogroups.com><mailto:UnidenBC780XLT%40yahoogroups.com>[email protected] > >m > > ><mailto:UnidenBC780XLT%40yahoogroups.com> > > > >Date: Thursday, October 7, 2010, 5:42 PM > > > > > > > >Hey all, > > > > i was just wondering i Live In NY on LONG > > > > ISLAND to be exact.. does anyone here know of > > > > the most upto date source of freq's and Trunk > > > > id's? I used to go to the Fordyce page but it > > > > was not ben update in years. Some of the info > > > > on that page i know for a fact in not accurate. > > > > Thnks. > > > > > > > >------------------------------------ > > > > > > > >If you have come here to find out about the > > > >Uniden BC-780 you have come to the right place! > > > >In fact the discussion of the BC-780 is the only > > > >acceptable topic on this list. Please. I hope > > > >this is clear to all group members. > > > >Community email addresses: > > > > Post message: > > > > > ><mailto:UnidenBC780XLT%40yahoogroups.com><mailt > o:UnidenBC780XLT%40yahoogroups.com><mailto:UnidenBC780XLT%40yahoogroups.com>[email protected] > >m > > ><mailto:UnidenBC780XLT%40yahoogroups.com> > > > > Subscribe: > > > > > > ><mailto:UnidenBC780XLT-subscribe%40yahoogroup > s.com>UnidenBC780XLT-subscribe@ > > >yahoogroups.com <mailto:UnidenBC780XLT-subscribe%40yahoogroups.com> > > > > > > > > Unsubscribe: > > > > > > ><mailto:UnidenBC780XLT-unsubscribe%40yahoogro > ups.com>UnidenBC780XLT-unsubscr > > ><mailto:ibe%40yahoogroups.com><mailto:ibe%40yah > > oogroups.com><mailto:ibe%40yahoogroups.com>[email protected] > > ><mailto:UnidenBC780XLT-unsubscribe%40yahoogroups.com> > > > > > > > > List > > > > owner: > > > > > > ><mailto:UnidenBC780XLT-owner%40yahoogroups.co > m>UnidenBC780XLT-owner@yahoogro > > >ups.com <mailto:UnidenBC780XLT-owner%40yahoogroups.com> > > > > > > > >Shortcut URL to this page: > > > ><<<<http://groups.yahoo.com/group/UnidenBC7 > 80X>http://groups.yahoo.com/group/UnidenBC780X > > > LT><http://groups.yahoo.com/group/UnidenBC780XLT>http://groups.yahoo.com/group/UnidenBC780XLT> > > > > <http://groups.yahoo.com/group/UnidenBC780XLT>http://groups.yahoo.com/group/UnidenBC780XLT>http://groups.yahoo.com/group > > >/UnidenBC780XLT > > > >The group files page: > > > ><<<<http://groups.yahoo.com/group/UnidenBC7 > 80X>http://groups.yahoo.com/group/UnidenBC780X > > > LT/><http://groups.yahoo.com/group/UnidenBC780XLT/>http://groups.yahoo.com/group/UnidenBC780XLT/ > > >files/><<http://groups.yahoo.com/group/Uniden > BC7>http://groups.yahoo.com/group/UnidenBC7 > >80XLT/files/><http://groups.yahoo.com/group/Uni > denBC780XLT/files/>http://groups.yahoo.com/group/UnidenBC780XLT/files/><<http://groups.yahoo.co>http://groups.yahoo.co>http://groups.yahoo.co > >o > > >o > > >m/group/UnidenBC780XLT/files/ > > > > > > > >Yahoo! Groups Links > > > > > > > >[Non-text portions of this message have been removed] > > > > > > > > > > > > > >Cheers Gig > > > > > >[Non-text portions of this message have been removed] > > > > > >[Non-text portions of this message have been removed] > > > > > > > > > >Cheers Gig > > > >[Non-text portions of this message have been removed] > > > >[Non-text portions of this message have been removed] > > > > > >Cheers Gig > >[Non-text portions of this message have been removed] > >[Non-text portions of this message have been removed] > > Cheers Gig [Non-text portions of this message have been removed]