Re: Re: Out of Band Error Message?

not sure but try turning off the truncking feature first. Press and hold
the Trucnking button until the M ( for moterola) goes off on the display,
then program as you wouold other regular freqs. ( type in freq and press
enter) after your done reactive the trucnking feature

this is off the top of my head, so may not be quite ritght, but give it a
try if no one else replies. Or download the manuall.

On 25 February 2012 21:06, bobcat21532 <[email protected]> wrote:

>
>
> 806.6125, 806.9125, 808.4750, 808.7500, 811.1375 are the new frequencies
> I'm attempting to "lay over" the old frequencies in the bank where I have
> the 800 trunk system programmed into.
>
> , --- n [email protected], MCH <mch@...> wrote:
> >,
> > What are the frequencies?
> >
> > Joe M.
> >
> > bobcat21532 wrote:
> > > I'm really rusting programming my 780XLT, but today the County
> implemented new frequencies in their Motorola Trunking system. I'm
> attempting to reprogram the trunked bank and am getting an error message
> "error - out of band".
> > >
> > > Any help (please and thank you!)?
> > >
> > > \Russ
> >
>
>  
>


[Non-text portions of this message have been removed]



------------------------------------

If you have come here to find out about the Uniden BC-780 you have come to the right place! In fact the discussion of the BC-780 is the only acceptable topic on this list. Please. I hope this is clear to all group members.