Re: Channels not staying on reciving channel

That did it ...  I turned off the data skip on both of my units..  they now
work fine...

Thanks Guys..

On Tue, Oct 16, 2012 at 9:20 PM, Bob Burns W9RXR <[email protected]> wrote:

> **
>
>
> At 07:39 PM 10/16/2012, MCH wrote:
>
> >1. Data Skip (I forget if the 780 has this feature)
> >
> >2. Negative delay. I think the 780 has this. It will only stop on a
> >channel for X seconds then move on.
>
> Yes to both.
>
> Data Skip is set in the System Data menu. Negative Delay is set in
> the Channel Data menu.
>
> Bob...
>
>  
>


[Non-text portions of this message have been removed]



------------------------------------

If you have come here to find out about the Uniden BC-780 you have come to the right place! In fact the discussion of the BC-780 is the only acceptable topic on this list. Please. I hope this is clear to all group members.