Re: New member saying Hi.

It's OK Don,there was just a handful so I just re-entered them into the scanner again.I noticed however that when the 780 was in 'scan' mode,it was possible to see the freqs changing on the Computer monitor,whereas on the scanner itself,the screen appears blank except for the word 'Scanning' until it stops on a frequency.Is this normal,can you tell me?
--- In [email protected], Don  wrote:
>
> Hi Gerry,
> 
> You may be able to recover the files. Used to be when files were 
> deleted, windoz changed the first letter to an *. So you may want to 
> search your HD for files with a * if that is not too daunting for you! LoL
> 
> Don KPC6NDB
> Upland, CA
> 34.10 -117.63 1250ft
> R-75 w/250Hz 2x R-71A w/250Hz R-70
> Perseus SDR-IQ SR-AF & LPF DSP599zx
> MFJ-784B HD-1418 AF-1 MSB-1
> PA0RDT Mini-Whip x2 @ 20ft
> RYO Active Antenna @ 20ft
> LFL1010 ALA100L x2
> 
> On 15-Jan-13 14:14, Bigjed wrote:
> > Don,thanx for that.You know,there are times when I think that I
> > shouldn't be allowed near a computer or a scanner without an appropriate
> > adult.Had I read the Manual beforehand I would have known to Press and
> > Hold the 'E' button to put the scanner into Remote mode.I know that
> > now.However in my disgust I had uninstalled ProScan from my PC.So having
> > discovered my faux-pas,I tried to reinstall it,only to be told that my
> > 30 day trial period had expired!Not to be outdone,I installed Proscan on
> > another PC that I just happened to have handy,held the 'E'
> > button,adjusted the baud rate and actually got the thing running.I have
> > now however inadvertently deleted all the frequencies that I had stored
> > in Bank 1.There was only 20 or so as I only got the scanner yesterday,so
> > it's not too bad.
> > (Note to self:Read the manual,Stupid!)
> >
> > Onwards and upwards!
> >
> > Gerry.