Re: 380 MHz Federal Trunk System

Clark,

I just programmed and saved in ARC with no flaws.  I set the type and
entered the tables first in the TRUNK System Settings pull down.  Then
grabbed the freqs using ADI, then turned the first freq under Trunk on
then highlighted the rest and selected Fill Down.  Next saved and
exit.  Reopened and everything still exist correctly.

Frank

--- In [email protected], "cerennie2000" <c.rennie1@v...>
wrote:
> 
> Has anyone successfully tracked the "Unidentified Federal 380 "
system 
> that 
> is listed
> at www.radiorefernce.com with either a BC785D or a BC250D scanner ?
It 
> is 
> an APCO 25 system, if that matters.
> I am unable to make either of these scanners accept the channels as 
> "Trunked", always changes to
> "conventional".
> I have tried programming manually and also with ARC PRO 250
software. 
> No luck.
> 
> 
> Clark





If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..