Re: 380 MHz Federal Trunk System

"fmonx" <fmonx-/[email protected]> Thu, 07 Apr 2005 16:04:14 -0000
Newsgroups gmane.recreation.radio.hardware.uniden.bc785d
Message-ID <[email protected]>

Unidentified Federal
Location:    Washington, DC MD
County:      2 counties
System Type: Motorola Type II SmartZone
System Voice:Analog and APCO-25 Common Air Interface
Sysid:       A73B

Custom Frequency Table

         1            2
Base:    406.1000     409.9000
Spacing: 12.5         12.5
Offset:  380          664

This is the Unidentified Federal system on RR for the DC area.  You
must be referring to another system.

Frank



--- In [email protected], Clark <c.rennie1@v...> wrote:
> Thanks Frank,
> I also did that but after downloading to the scanner, the Trunk
channels
> changed to off, and the channels in the scanner displayed
"conventional"
> and not "M" as it should be.
> 
> The replies from the www.radiorefernce.com  forum stated that no
present
> scanner is able to track a 380 MHz trunk system.
>   But the new BCD396T will.
> 
> Clark
> 
> At 06:43 PM 4/6/2005, you wrote:
> 
> 
> 
> >Clark,
> >
> >I just programmed and saved in ARC with no flaws.  I set the type
and
> >entered the tables first in the TRUNK System Settings pull down. 
Then
> >grabbed the freqs using ADI, then turned the first freq under
Trunk on
> >then highlighted the rest and selected Fill Down.  Next saved and
> >exit.  Reopened and everything still exist correctly.
> >
> >Frank
> >
> >--- In [email protected], "cerennie2000"
<c.rennie1@v...>
> >wrote:
> > >
> > > Has anyone successfully tracked the "Unidentified Federal 380 "
> >system
> > > that
> > > is listed
> > > at www.radiorefernce.com with either a BC785D or a BC250D
scanner ?
> >It
> > > is
> > > an APCO 25 system, if that matters.
> > > I am unable to make either of these scanners accept the
channels as
> > > "Trunked", always changes to
> > > "conventional".
> > > I have tried programming manually and also with ARC PRO 250
> >software.
> > > No luck.
> > >
> > >
> > > Clark
> 
> 
> [Non-text portions of this message have been removed]





If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..