Re: Scanner Program - USB??

Hi,

ScanControl (www.scannersoft.com) fully supports the BC785D and 
offers compatible USB Converters in our accessories section.

3D Technologies

--- In [email protected], "Troy" <thefirechief750@y...> 
wrote:
> 
> Thank you all for the replies to my question.  I had former bad 
> experiences using USB conversions.  They caused serious 
complications 
> while programming a radio.  I have since purchased the kit and will 
> fire it all up in the next few days.  
> 
> Thanks again to you all!!
> 
> 
> --- In [email protected], "Troy" <thefirechief750@y...> 
> wrote:
> > 
> > Hello everyone.  I have searched this group and did not locate 
the 
> > answer to my question so here it goes....
> > 
> > I have a few bc786d's and a 796d.  I purchased the ARC250 Pro and 
> have 
> > been unable to use it due to all my PC's having USB ports only.  
> > My question is, has anyone been able to use any converters that 
will 
> > accept USB connections in order to program these rigs?  I was 
> > surprised to read that the software suppliers add that they are 
not 
> > responsible for damage caused by the use of USB's......
> > 
> > Help!!!





If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..