RE: WSJT-X - no transmit audio
| Newsgroups | gmane.recreation.radio.hardware.yaesu.ft100 |
|---|---|
| Message-ID | <[email protected]> |
Hi Roy, Don't quote me on this as I haven't done it myself but have you set up the menus correctly, such as Menu 34 which sets up the digital mode and are you selecting DIGital as the mode (long press from the AM mode on the mode button)? I have a feeling that these are settings you need to make to get audio in through the rear socket. 73..Eric VK2VE From: [email protected] <[email protected]> Sent: Friday, 17 August 2018 22:00 To: [email protected] Subject: [FT100] WSJT-X - no transmit audio Is anyone used WSJT-X with FT100D? Can you tell me your WSJT-X rig configuration and any other configuration/menu setting you did? I am using an external USB sound card that is working fine. I am not getting audio out from my computer to the FT100D. The sound card is fine, the cables going from sound card to the 6-pin data connector is fine. CAT control works perfectly. I'm stumped. My WSJT-X rig settings: PTT Method = CAT Mode = USB Test CAT = Green Test PTT = Red Tune/Transmitting in this configuration - Rig goes to transmit, but no audio out PTT Method = CAT Mode = Data/Pkt Test CAT = Green Test PTT = Red Tune/Transmitting in this configuration - WSJT-X error message "Hamlib error - invalid parameter while setting current VFO mode" PTT Method = CAT Mode = Data/Pkt and manually set FT100D to DIGI mode WSJT-X switches mode to USB on transmit Trying any other PTT method does not work The FT100D works fine when working SSB with mic. Thanks for any help, Roy K2RMA -- *************************************************************** * No trees were destroyed in the sending of this message, * however, a significant number of electrons were terribly inconvenienced ***************************************************************