Re: File - FT100 Group Guidelines.txt

At the bottom right of all messages you have the nomenclature 
UNSUBSCRIBE which you allow you to unsubscribe yourself.

Jean-Claude

Am 04.11.2018 um 18:09 schrieb 'Steve Schneider' [email protected] [FT100]:
>
> Please unsubscribe me from this Group. I donÂ’t have an FT 100 and have 
> no interest in it.
>
> Thanks and all the Best
>
> Steve Schneider
>
> Read Chesterton
>
> *From:*[email protected] [mailto:[email protected]]
> *Sent:* Thursday, November 01, 2018 1:13 AM
> *To:* [email protected]
> *Subject:* [FT100] File - FT100 Group Guidelines.txt
>
>
> The FT100 Group averages around 50-60 messages per month.
> Because the volume of messages is rather large, I would
> like to remind everyone of a few long-standing FT100
> guidelines to follow. Most of you do so already.
>
> Look at the home page for the FT100 Group for links to the
> FAQ, Knowledge Base, and Manuals for the FT-100/D.
>
> 1. Civility. (This is practiced well by our members!)
>
> 2. Please sign your messages with name and call sign, e.g.,
> Fred - W1XYZ.
>
> 3. When replying to a posting (message), kindly delete all
> unnecessary text including the trailing text. Only leave the text
> from the prior message to which you are replying ... <snip> the
> rest. I f one desires to read the entire thread, the command [Up
> Thread] at the top of the message can be used to read the entire
> discussion. Remember also that a lot of members have slow
> connections and some even pay connect time or characters rx/tx. This
> also helps the clarity of your message.
>
> 4. When replying to a post, please decide if your comment should be
> to the entire group of almost 4,000 or email directly to the author of the
> post. When you click on "Reply," it goes to everyone. To reply
> direct (simplex), you should click on the email address following the
> user ID line at the top of the post. Notice that only a part is
> shown for privacy. Also, please think about if what you are about to
> post in reply to the group really should be to the group ... replies
> like "I sure do agree with that" doesn't add much to the group. Send
> thoughts like those direct to the poster please.
>
> 5. It is fine for members to post somethin g for sale or wanted to
> buy ... once per item(s). All questions and offers to buy/sell
> should be made directly to the poster, not to the Group. The member
> posting the FS or WTB may post that the item(s) was/were
> sold/purchased.
>
> 6. Posting of commercial items for sale by manufacturers or dealers
> is also fine, but should be done on an infrequent basis. The FT100
> members benefit by learning of hardware, software, sales, etc. before
> it appears in magazines, etc.
>
> 7. New members are all moderated until their first posting. If it
> follows the guidelines, it is approved and the member is change to
> unmoderated status. This list is a partially moderated list, i.e.,
> only first message is moderated while later messages are monitored
> after posting. If an unmoderated posting is found by the moderators
> to have a problem, then the poster is contacted directly to resolve.
> Actions are taken against those that chronically violate the rules.
> The re ason for this form of moderation is to block spammers from the
> list and it has been working.
>
> 8. Do not add disclaimers to your posts that (1) restrict the ability
> of other members to use the information you post, (2) claim a copyright
> to your post, or (3) to claim any type of "rights" as a consequence of
> another member replying to you post either directly to you or to the 
> group.
>
> Thanks to all es 73,
> Barry - W4WB
> Moderator
>
>
>
> ------------------------------------------------------------------------
> AVG logo <https://www.avg.com/internet-security> 	
>
> This email has been checked for viruses by AVG antivirus software.
> www.avg.com <https://www.avg.com/internet-security>
>
>
> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
>