Re: Clipping

"Rick Booth [email protected] [FT100]" <[email protected]> Mon, 22 Jul 2019 13:34:49 -0700

Newsgroups	gmane.recreation.radio.hardware.yaesu.ft100
Message-ID	<[email protected]>

Low voltage is possible but if you have over 13 volts of DC input "under 
load" then it is not likely unless a circuit failure has occurred that 
results in increased gain or output swing of the audio.  Too high of 
microphone gain can cause clipping.  There is a speech processor built 
into the FT100 that may not have the parameters set correctly.

Rick
w6nzk

On 7/22/2019 12:26 AM, [email protected] [FT100] wrote:
> Hi David is there a fix for this ?
>
> Regards Chris
>
>
>
>
> On Mon, Jul 22, 2019 at 8:18 AM +0100, "david.browne7-XZoyATsUNX5Wk0Htik3J/[email protected] 
> [FT100]" <[email protected] <mailto:[email protected]>> wrote:
>
>     Low voltage
>
>     On 22 Jul 2019 7:37 am, "[email protected] [FT100]"
>     <[email protected]> wrote:
>
>         Hi group. I have been told that my speech may be clipping on
>         the Ft100.
>         Has anyone got any clues ?
>
>         Regards Chris
>
>
>