Re: Clipping
| Newsgroups | gmane.recreation.radio.hardware.yaesu.ft100 |
|---|---|
| Message-ID | <[email protected]> |
Hello Chris, No, I don't have any settings. I haven't used my radio in years. :o( Rick w6nzk On 7/22/2019 3:36 PM, [email protected] [FT100] wrote: > Hi Rick and thanks for the reply. I am using a standard microphone. > Have you any specific settings you could recommend ? > Thanks in advance. > > Chris > > Regards Chris > > > > > On Mon, Jul 22, 2019 at 9:48 PM +0100, "Rick Booth [email protected] > [FT100]" <[email protected] <mailto:[email protected]>> wrote: > > Low voltage is possible but if you have over 13 volts of DC input > "under load" then it is not likely unless a circuit failure has > occurred that results in increased gain or output swing of the > audio. Too high of microphone gain can cause clipping. There is > a speech processor built into the FT100 that may not have the > parameters set correctly. > > Rick > w6nzk > > On 7/22/2019 12:26 AM, [email protected] [FT100] wrote: >> Hi David is there a fix for this ? >> >> Regards Chris >> >> >> >> >> On Mon, Jul 22, 2019 at 8:18 AM +0100, >> "david.browne7-XZoyATsUNX5Wk0Htik3J/[email protected] [FT100]" <[email protected] >> <mailto:[email protected]>> wrote: >> >> Low voltage >> >> On 22 Jul 2019 7:37 am, "[email protected] [FT100]" >> <[email protected]> wrote: >> >> Hi group. I have been told that my speech may be clipping >> on the Ft100. >> Has anyone got any clues ? >> >> Regards Chris >> >> > >