| Newsgroups |
gmane.recreation.radio.hardware.yaesu.ft100 |
| Message-ID |
<[email protected]> |
Hi Chris,
Cool. It is a very good but a little complicated radio to use. I am
sure that after you use it a while you will be on your way to having a
very effective radio. There used to be people who sold "cheat sheets"
for this radio (and others) with all the settings and how to get to
them. I had one for this radio when I was using it.
73s
Rick
w6nzk
On 7/25/2019 1:02 AM, [email protected] [FT100] wrote:
> Hi all, I reduced the mic gain as suggested ang worked into Germany on
> 6 meters.
> No clipping or distortion, the mic gain setting is at 47 on the scale
> and about 6 inches away from my mouth.
>
> Regards Chris
>
>
>
>
> On Tue, Jul 23, 2019 at 12:04 AM +0100, "Rick Booth [email protected]
> [FT100]" <[email protected] <mailto:[email protected]>> wrote:
>
> Hello Chris,
>
> No, I don't have any settings. I haven't used my radio in years. :o(
>
> Rick
> w6nzk
>
> On 7/22/2019 3:36 PM, [email protected] [FT100] wrote:
>> Hi Rick and thanks for the reply. I am using a standard
>> microphone. Have you any specific settings you could recommend ?
>> Thanks in advance.
>>
>> Chris
>>
>> Regards Chris
>>
>>
>>
>>
>> On Mon, Jul 22, 2019 at 9:48 PM +0100, "Rick Booth
>> [email protected] [FT100]" <[email protected]
>> <mailto:[email protected]>> wrote:
>>
>> Low voltage is possible but if you have over 13 volts of DC
>> input "under load" then it is not likely unless a circuit
>> failure has occurred that results in increased gain or output
>> swing of the audio. Too high of microphone gain can cause
>> clipping. There is a speech processor built into the FT100
>> that may not have the parameters set correctly.
>>
>> Rick
>> w6nzk
>>
>> On 7/22/2019 12:26 AM, [email protected] [FT100] wrote:
>>> Hi David is there a fix for this ?
>>>
>>> Regards Chris
>>>
>>>
>>>
>>>
>>> On Mon, Jul 22, 2019 at 8:18 AM +0100,
>>> "david.browne7-XZoyATsUNX5Wk0Htik3J/[email protected] [FT100]" <[email protected]
>>> <mailto:[email protected]>> wrote:
>>>
>>> Low voltage
>>>
>>> On 22 Jul 2019 7:37 am, "[email protected] [FT100]"
>>> <[email protected]> wrote:
>>>
>>> Hi group. I have been told that my speech may be
>>> clipping on the Ft100.
>>> Has anyone got any clues ?
>>>
>>> Regards Chris
>>>
>>>
>>
>
>