Alignment Procedure

"Dennis, Philippines low budget HAM" <[email protected]>
Newsgroups gmane.recreation.radio.hardware.yaesu.vr-500
Message-ID <[email protected]>
Hi all,

I couldn't find the procedure in the files section but I kept a note 
so here is the procedure :


ATT 0ff (Func + 8)
Enter Menu (Func + ent)
Menu items 5, 6, & 19 set to off
Menu items #23 anything but off, #10 Key beep On
Menu item 1 in Manual 
Make sure in NFM
Enter 1250.375 followed by enter
Func + 5 (long press)
Then choose menu 1 (press 1)
Enter 123.125 followed by enter
Func + 5 (long press)
Choose menu 2 (press 2)
Enter 448.25 followed by Enter
Func +5 (long press)
Choose Menu 3 (press 3)
Battery icon should be flashing ... if not restart the procedure 
until it does !!
Tune strong station on NFM in my case 462.6 (GMRS ch17) . GMRS in the 
uk ?? whoops!
Func + 9 (S meter set)appears
Func + 1 (S meter +) appears
Press BS ( a beep will be heard)
Tune a weak station on NFM in my case scanner no antenna and flat 
batts in handi talkie ;-)
Func + 2
Press BS until beep is heard 
Press CLR (VR500 restarts) 



Regards to all from the warm, tropical & always sunny island of Bohol 
in the Philippines

Dennis, DV7-BKO







------------------------ Yahoo! Groups Sponsor --------------------~--> 
Check out the new improvements in Yahoo! Groups email.
http://us.click.yahoo.com/6pRQfA/fOaOAA/yQLSAA/ELTolB/TM
--------------------------------------------------------------------~-> 

Post message:         [email protected] 
Subscribe:            [email protected] 
Unsubscribe:          [email protected] 
List owner:           [email protected] 





Ejoy the list!! 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/VR-500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.