Re: Clock Display on Mem & VFO Screens?

Hi there,

Do you mean that at the lower right hand corner where there is the little clock face, it just shows "--:--"?

If so, then:
Stop scanning if you're doing it.
Press "F" then "Ent"
Cursor down to "Misc" then "Ent"
Cursor down to "Clock" then "Ent"
Enter your local time with the keypad then "Ent'
Keep on pressing "Ent" until you get back to the main display.
Done.

See previous messages about the clock keep-alive battery - if you lose the clock when you turn off the 12volt power supply, you're not alone!

Agreed, it's a great radio - although HF performance is not that startling compared to a dedicated HF receiver but that's par for the course on most wideband receivers.

Cheers - Martin ZL2MC



--- In [email protected], "leonard_trembley" <leonard.trembley@...> wrote:
>
> HI, new owner here, love this thing, far exceeds my AR8600. Just starting to populate the Memories and don't know how to get the Clock to display, and be able to adjust the frequency/tune the Radio at the same time, other than the SW Presets (Func + 4). How can I add the Clock display?
>