Re: no receive on am

I gave up on FTBCat, found it was more for transceivers. Now I use FTBVR5K to just catalogue and organise my memory locations. Works a treat. Locking out the secondary VFO speeds up scanning too.

Sorry, got OT.

Hope that you haven't loaded something into the EEPROM to tell it something different. If you have downloaded all your frequencies and other info, I would be inclined to do a total microprocessor reset as per tha handbook page 56 next.

Cheers - Martin ZL2MC

--- In [email protected], "cdjordan523@..." <cdjordan523@...> wrote:
>
> i can go to fm and hit the band scope and it hits on all the local broadcast stations
> 
> 
> 
> --- In [email protected], lambsona@ wrote:
> >
> > god point though on mine it only whacks out the SSB's 
> > 
> > 
> > 
> > ----- Original Message ----- 
> > From: "G1ITV" <g1itv@> 
> > To: [email protected] 
> > Sent: Saturday, November 27, 2010 6:07:55 PM 
> > Subject: Re: [YaesuVR-5000] Re: no receive on am 
> > 
> > 
> > 
> > 
> > 
> > 
> > Have you got Band Scope activated ? 
> > 
> > 
> > 
> > -------Original Message------- 
> > 
> > From: cdjordan523@ 
> > Date: 28/11/2010 00:57:51 
> > To: [email protected] 
> > Subject: [YaesuVR-5000] Re: no receive on am 
> > 
> > I hooked another receiver up to the same coax and same antenna and it works, 
> > could it be a setting I have messed up or something inside of the radio. I 
> > usually use a cat program called ftbcat v1.15 
> > 
> > 
> > 
> > 
> > 
> > [Non-text portions of this message have been removed]
> >
>