Re: orogen: Using PROJECT_SOURCE|BINARY_DIR instead of CMAKE_x_DIR
"Leopold Palomo-Avellaneda" <[email protected]>
| Newsgroups | gmane.science.robotics.orocos.devel |
|---|---|
| Message-ID | <[email protected]> |
A Dimarts, 11 de juny de 2013, Peter Soetens va escriure:
> Hi,
>
> We're looking into chaining different packages into a single cmake
> build, using catkin as the glue. There are two things to fix for doing
> this:
>
> 1. never use CMAKE_SOURCE/BINARY_DIR but use the PROJECT_...
> equivalent (refers to the closest project() statement)
> 2. never define a target twice, both cmake targets as make targets,
> for example, the 'regen' target.
>
> If we would:
> 1. replace all these CMAKE_ occurences to PROJECT_...
> 2. rename 'regen' to 'regen-${PROJECT_NAME}'
>
> Would we be fine or do I overlook something ? Would this break the
> Rock workflow ?
>
this change will mean that orocos will depend to build on catkin?
I would prefer that no ... please...
Regards,
Leo
--
--
Leopold Palomo-Avellaneda <[email protected]>
Institut d'Organització i Control de Sistemes Industrials
Universitat Politècnica de Catalunya
Avda. Diagonal 647, pl. 11
08028 BARCELONA (Spain)
Tel. +34-934017163
Fax. +34-934016605
--
Orocos-Dev mailing list
[email protected]
http://lists.mech.kuleuven.be/mailman/listinfo/orocos-dev