Re: Fail one test

Quoting Leopold Palomo-Avellaneda <[email protected]>:

> Hi,
>
> I have compiled orocos-0.24.1 in a Debian etch with the gcc (GCC) 
> 4.1.2 20060901 (prerelease) (Debian 4.1.1-13) with success. No 
> problem :-)
>
> However I have found that if I make check, I can compile all the test, but
>
>
> make[3]: Entering directory 
> `/home/palomo/robotica/orocos/orocos-0.24.1-etch/build/tests'
> /bin/sh: line 4: 14531 Segmentation fault      ${dir}$tst
> FAIL: core-test
> .............
>
> OK (13)
> PASS: task-test
> ...........
>
> OK (11)
> PASS: event-test
> .....
>
> OK (5)
> PASS: taskcontext-test
> ..................
>
> OK (18)
> PASS: parser-test
> .................
>
> OK (17)
> PASS: program-test
> ......
>
> OK (6)
> PASS: state-test
> ===================
> 1 of 7 tests failed
> ===================
> make[3]: *** [check-TESTS] Error 1
>
>
> is this normal?

No.
Are you doing this on an SMP system or on a dual core processor ? Did you
select the correct CPU/architecture in the 'make configure_packages' step ?

Peter


-- 
www.fmtc.be

Flanders' MECHATRONICS Technology Centre vzw
Maatschappelijke zetel: Diamant Building, A. Reyerslaan 80, B-1030 
Brussel, Belgie
BTW BE 0860.286.268

*****DISCLAIMER*****
This e-mail and/or its attachments may contain confidential 
information. It is intended solely for the intended addressee(s). Any 
use of the information contained herein by other persons is prohibited. 
FMTC does not accept any liability for the contents of this e-mail 
and/or its attachments.
********************

----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.