Re: FW: Model Rocket Plan

On Sun, 2004-08-29 at 22:27, John Carmack wrote:
> >
> >         If we go this kind of route, we can have BoJo make use deflectors out
> >of silicon carbide relatively cheap. Wire EDM is magical. With eight
> >deflectors, you can even get roll control this way.
> 
> Which project is BoJo?

	BoJo, Inc is a company located in the same building as our shop. They
have loaned us an inordinate amount of equipment, time, and expertise
over the past couple of years, including the 2.5 axis CNC mill we are
using. They specialize in injection molding dies, and they're also
making a line of nifty little non-marring prybars. www.bojoinc.com

	-p