Re: Is rst2odt -l cs supposed to work?

Matěj,

I believe I've fixed the two issues you have reported below.

1. The image now has, I believe, a reasonable width and height.
   But, you will have to see if you agree.

2. The label of the admonition/note has been translated.

A fixed version of ``docutils/writers/odf_odt/__init__.py`` is
attached to a separate message.

You can use "-l" or "--language" and any of:

    cs-CZ
    cs_CZ
    cs-cz
    cs_cz

They all have the same effect, as far as I can tell.  But, "-l cs"
does *not* work.  I don't know whether it should or not.  You can
try "-l cs", but you end up with the language "cs-US", which I'm
guessing you do not want.

And, thanks for your guidance on this.

Dave

On Wed, May 10, 2017 at 12:24:48AM +0200, Matěj Cepl wrote:
> On Tue, 2017-05-09 at 13:28 -0700, Dave Kuhlman wrote:
> 

[snip]

> A way better but not there yet.
> 
> When running rst2odt --language=cs_CZ v_chramu.rst v_chramu.odt I
> get the attached result with two problems (PDF generated via
> rst2xetex and xelatex is correct on both counts):
> 
> 	1. image is completely screwed up
> 
> 	2. .. note:: doesn’t have the Czech label “Poznámka”
> 
> However, styles seems to be correct. Also, I am not sure, whether
> I should use cs, cs-CZ, or cs_CZ language code.
> 
> Thank you for the great work so far.
> 
> Matěj
> 

[snip]



-- 

Dave Kuhlman
http://www.davekuhlman.org

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Docutils-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/docutils-users

Please use "Reply All" to reply to the list.